Glass Plate Setup and Assembly Manual
Page 11
A.3
Assembling the Gas Spring to the Lamp
Before assembling the glass plate to the Bookeye
®
3 scanner, a special gas spring has to
be assembled to each lamp.
Place the lamp on a desk a shown in the picture below.
Picture 9: Assembling gas spring to lamp
Slide in the gas spring the direction of the arrow from the bottom side. Fasten the screw
on the gas spring bracket, only hand-screwed at first.
On the bottom side of the notch of the lamp, two T-slot nuts are found. They are used to
hold the lamp in place.
Insert an additional T-slot nut in the notch on the front side of the lamp beam. They come
with the glass plate option. Move the T-slot nut to a position in the middle of the lamp. It is
used to fasten the bearing and will be moved to its correct position later.
When the gas springs are assembled to the lamp, slide the lamps into the main body.
Perform the assembly steps in reverse order from topic 8 to 1 as described in chapter A.2.
