![background image](http://html.mh-extra.com/html/image/6-5/6-5_manual_2044958027.webp)
27
The Adjustable Pulley Plates (23) have several sets of
adjustment holes. By moving one or both pulleys to a differ-
ent set of holes, you will tighten the cables.
To move one Pulley, remove the 3/8” Nylon Locknut (50)
and the 3/8” x 2” Bolt (54). Remove the Cable Trap (25) and
the Pulley (24) from the Adjustable Pulley Frame (23). Re-
attach the Pulley and the Cable Trap to the appropriate
adjustment hole in the Pulley Frame.
Note: Begin by mov-
ing one Pulley to the second adjustment hole. If the
Cables are still too loose, move the same Pulley to the
third hole. If additional adjustment is needed, move the
second Pulley until the Cables are tight.
23
50
25
24
54
Trouble-shooting and Maintenance
Note: For clarity, the Shroud is not shown. The Shroud
does not have to be removed to tighten the Cables.
The bolt at the end of the Weight Cable (72) is one of the
means for tightening the Cables. Use the following proce-
dure for tightening the Cables: Loosen the 1/2” Plain Nut
(100). Thread the bolt at the end of the Weight Cable into
the Weight Tube (17) until all Cables are tight and rest firmly
in the grooves of all Pulleys. Then tighten the 1/2” Plain Nut
(100) onto the 1/2” Washer (98).
Note: If a Cable tends to slip off the Pulleys often, the
Cable may have become twisted. Remove the Cable and
re-install it.
If the Cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this manual.
Bolt
72
100
98
17
Inspect and tighten all parts each time you use the home gym. Replace any worn parts immediately. The home
gym can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
Adjustment
Holes
Tightening the Cables
Woven cable, the type of cable used on the home gym, can
stretch slightly when it is first used. If there is slack in the
Cables before resistance is felt, the Cables should be tight-
ened.
Slack can be removed from the cables in several ways:
Remove the 3/8” x 4” Bolt (60), the 3/8” Flat Washer (48),
the Large Cable Trap (32), the “V”-Pulley (27) and the 3/8”
Nylon Locknut (50) from the Press Frame (8). Move the
Pulley and the Cable Trap to a hole that is closer to the
Press Upright (2). This will tighten the cable. Reattach the
“V”-Pulley assembly, the Bolt and the Nylon Locknut.
Make
sure that the Cable Trap and Cable remain oriented as
shown.
8
74
2
60
48
32
27
50