17
36. Wrap the Ab Cable (74) around a 3 1/2” Pulley (24) in
the direction shown. Place two Pulley Covers (47)
over the Pulley, so that the slots in the Pulley Covers
are placed over the Cable. Attach the Pulley and the
Pulley Covers to the indicated hole in the Press
Upright (2) with a 3/8” x 3 3/4” Bolt (59), two 3/8” Flat
Washers (48) and a 3/8” Nylon Jam Nut (63).
Make
sure that the Cable is between the Pulley and the
welded pin (not visible in the drawing) on the
Upright.
36
48
59
2
47
24
37. Identify the Low Cable (75). It is approximately
312 1/4” long, and it has a ball on one end and a
closed loop on the other end.
Route the end of the Low Cable (75) with the closed
loop through the cable guide on the Butterfly Base
(4). Wrap the Low Cable (75) around a 3 1/2” Pulley
(24) in the direction shown. Attach the Pulley and a
Cable Trap (25) to the welded bracket on the Butterfly
Base with a 3/8” x 2” Bolt (54) and a 3/8” Nylon
Locknut (50).
37
4
75
50
24
54
25
38. Wrap the Low Cable (75) around a 3 1/2” Pulley (24)
in the direction shown. Attach the Pulley and a Cable
Trap (25) to the indicated hole in the Butterfly Upright
(1) with a 3/8” x 3 3/4” Bolt (59), a 3/8” Flat Washer
(48) and a 3/8” Nylon Jam Nut (63).
Make sure that
the Cable Trap is oriented as shown.
38
25
63
48
59
1
24
75
Welded
Bracket
Cable
Guide
63
48
47
74
