Section 2
Section 6
System Maintenance
23
23
2) Draw Straight Out
1) Remove 4 screws
The Magazine Holder may be taken out of the tool
with or without a clip magazine & clips in place.
Magazine Holder Assembly
Figure 16
Changing Grip Pads (Copper Electrodes)
The grip pads are a wear item and need to be
replaced about every 5,000 welds (100
magazines) or if they have been damaged in
some way.
You can check pads for wear. Recommended
minimum thickness of the copper grip pad is
.154 inches (3.9mm). If the copper pad is
below this it is time to change the pad.
1. Remove Spark Shield (Figure 13)
2. Remove two Torx screws (2 for each grip
pad) from the grip pads (Figure 15). Use a T8 torx drive.
3. Once the grip pads are removed, inspect the fingers for any damage. Clean as necessary.
4. Reverse steps to install new grip pads. NOTE: Weld current passes through these pads. It is important that
the screws for these pads are tight.
Changing Magazine Holder Assembly
The Magazine Holder is a key component to properly dispensing the QuikLinx Clips. As such, it has been
engineered to be easily replaceable in 4 steps.
1. Open the rear door
1. Remove a quantity of (4) #4-40 (3/32 Hex key) socket head cap screws that secure the Magazine Holder
Assembly in place.
2. The Magazine Holder will now easily slide out the rear of the tool.
3. Slide the new Magazine Holder Assembly back into the tool (Note orientation in Figure 16. There is no
up/down orientation. Either choice will work properly).
1) Remove two Torx Screws
for each pad using a T8
Torx Driver
2) Pads will come off the fingers
Figure 15
Summary of Contents for QuikLinx 10700
Page 9: ...Safety Precautions Section 1 8 Symbols and Definitions ...
Page 28: ...Section 2 Section 7 Exploded Diagram 27 Figure 21 1 9 8 12 13 4 5 7 6 10 11 3 2 ...
Page 30: ...Section 2 Section 7 Exploded Diagram 29 Figure 22 5 1 2 3 4 ...
Page 32: ...Please visit us on the web www imageindustries com twitter studwelding ...
