Image Industries QuikLinx 10700, Operation Manual

Page: 13 / 32

Section 3
Normal Operation
12
Step 2 Remove Empty Clip Carrier (If one is present)
Using a your finger on the top finger hold and your thumb on the bottom thumb hold
(See Figure 5) pull rearward (See Figure 6) and the clip carrier will unsnap and come out
easily.
DO NOT REMOVE THE CLIP CARRIER WHEN THERE ARE CLIPS REMAINING IN
THE TOOL.
Discard the empty clip carrier into the recycling bin.
Step 3 Insert a New Magazine
Keeping the rear door open, slide the magazine into the gun with the green
retention pin leading (See Figure 7). The green retention pin will eject the red clip
advance block from the last magazine. Discard the ejected red clip advance block
into the recycling bin.
Notice the orientation of the clip carrier as shown in Figure 6. There is no top or
bottom orientation. Either orientation is correct.
The clip carrier will snap in place. It may need a push with your thumb to snap
the clip carrier in place. DO NOT FORCE the magazine in place. If the magazine
will not snap into place see trouble shooting guide.
ONCE A MAGAZINE IS FULLY INSERTED IT CANNOT BE REMOVED. IT
LOCKS INSIDE THE TOOL. CLIPS CAN ONLY BE EMPTIED FROM THE
FRONT.
Step 4 Close the Rear Door
Close the rear door. It will snap in place. The tool will not function without the
rear door closed.
Slide New Magazine
Into tool
Empty QuikLinx
Clip Carrier
Finger Hold
Thumb Hold
Figure 5
Draw Straight Out
Empty Clip Carrier
Figure 7
Figure 6