/
Page 16
Manual
A.5 Device Location
Note:
Picture 1 shows a sketch of a
Wide
TEK
®
25
scanner, but the distances around
the scanner are generally valid for both scanner models.
Please allow a minimum of 150 mm (6 inch) from any side walls and 300 mm (12 inch)
from a back wall. Leave one meter (3 feet) minimum distance from any door or entrance
way. Use the illustration below as a guide.
Picture 1: Minimum distances
Do not operate the scanner in an area that has poor air circulation and/or that is non-
ventilated.
Place scanner on a flat and solid base. The load bearing capacity of the base must
correspond to the device weight.
Choose a location that complies with the limits of temperature and humidity. Refer to the
technical specification.
Important:
After transporting the scanner to a new environment, allow at least one hour
for temperature adaption before using the device.
Temperature adaptation means:
A fast change from cold to warm environmental conditions can build up
condensation inside the housing. This will result in unfavorable scanned
images and could cause permanent damages to the unit.
