Ilumiline 36 IP Optic RGB QRG
7
Ilumicon
and DMX
Controllers
The Ilumiline 36 IP Optic RGB can operate with either an Ilumicon or a
DMX controller. Use the standard DMX connection, as shown on the
previous section (
DMX Junction Box Wiring
) to connect this product to
any of those controllers.
For more information, please refer to the
Ilumiline 36 IP Optic Series User
Manual
.
Settings
To configure the Ilumiline 36 IP Optic RGB, use the Ilumicode.
Ilumicode
Connections
The diagram below shows how to connect the Ilumicode to this product.
Note that this connection will control multiple fixtures at the same time,
all having the same DMX address. To assign individual DMX addresses to
each fixture, you must connect the Ilumicode unit to each fixture,
individually. This means that you will also have to disconnect the DMX
output of the fixture under configuration if there are other fixtures
connected to it.
Ilumicode
Connection
Diagram
ILUMINARC suggests you to connect no more than 20 fixtures in this
mode, while keeping the total distance to less than 60 m (197 ft).
Otherwise, you might need to use an optically isolated signal amplifier.
Ilumicode
Addresser
