SECTION 4
ILMOR ONE-DRIVE OWNER’S MANUAL
4-16
© 6/2016 Ilmor Marine Engines, Version 1.0
b. If necessary, add oil until an air-free stream of oil flows from the oil
vent hole.
c. Install the oil vent plug and gasket. Torque the oil vent plug.
NOTICE: Oil level in the oil reservoir will rise and fall during stern-drive
operation; always check the level when the stern-drive is cool and the
engine is shut down.
Lubricating the Drive Unit and Universal-joint Shaft Splines and
O-rings
When you remove the stern-drive unit from the transom assembly, your
should first remove the quick connect fitting. This will prevent oil leaks
from the reservoir tank.
Figure 4-15
Remove the drive unit and lubricate the universal-joint shaft splines
(
Figure 4-16, 1
) and the O-rings (
Figure 4-16, 2
).
1
2
Figure 4-16
