29
•
Before working on the machine it is advisable to follow the steps below:
1. Cut the machine voltage.
2. Block the starting-up mechanisms.
3. Check that there is no voltage in the circuits, including the auxiliaries and supplementary
services.
4. Wait until the wheel has stopped completely.
The mentioned list should be considered indicative and not binding, since there may be specific
safety rules within specific safety procedures.
•
Periodically
control:
-
The mechanical parts are firmly secured and the machine support screws are in good
condition.
-
Correct positioning and fixing and the condition of the leading-in wires and isolation
components.
-
Machine and electric motor temperature. In case of irregularity, stop the machine
immediately and proceed with its repair.
-
Machine shake. In case of irregularity, stop the machine immediately and proceed with
its repair.
Because of the complexity of cases dealt with, the installation, use and maintenance instructions in
this manual do not intend to examine and deal with all possible service and maintenance situations.
If supplementary instructions are necessary or if specific problems arise, do not hesitate to contact
the machine distributor or the manufacturer.
3. INSTALLATION AND ASSEMBLY
GENERAL
•
Assembly and installation of our pumps is only permitted in swimming pools or tanks
complying with regulation HD 384.7.702. In case of doubt please consult a specialist.
•
The pumps come with a pre-filter with an interior basket to collect large particles since
these may damage the interior hydraulic part of the pump. This pre-filter means that the
pump assembly must be done in a horizontal position.
•
All pumps come with a two-drill foot to allow for them to be fixed in the floor by means of
an anchor (Fig.1).
