REVEXmax - User’s Manual
4
Measurements
4
Measurements
4.1
Selection of the function
The measured function can be selected automatically in sequence mode (see chap-
ter 5.6) or manually (see Figure 4).
Figure 4: Keyboard
4.2
Measurement mode control
The beginning, process and ending of measurements are controlled by the
[TEST]
key. If the
[esc]
key was pressed during the measurement, then it will be cancelled
(the measured value is not saved).
4.2.1
Measurement mode
The measurement can start in four different measurement modes:
•
One measuring cycle
– after the
[TEST]
key is pressed and released, one
measuring cycle starts and is completed after a few seconds. The result of the
measurement is displayed.
•
Continuous measurement
– press the
[TEST]
key; measurement is in progress
and current measured values are displayed until the
[TEST]
key is released.
The result of the measurement is displayed.
•
Locking the measurement
- press the
[# ARET]
key and then press the
[TEST]
key. Then release both keys. The measurement is in progress and the
current measured values are displayed until the
[TEST]
key is again pressed
and released. Reverse steps are possible too: press the
[TEST]
key and then
press the the
[# ARET]
key.
•
Automatically locking the measurement
– this function can be set in the menu
Setup. Measuring is similar to Locking the measurements but the
[# ARET]
key is not used.
Measuring in process is indicated by the symbol
.
c
2019 ILLKO, s.r.o.
Page 20
