Operating manual - English
ECODRILL 2000 CODE
25
8.7
Cutting narrow-stemmed Laser (sidewinder) type keys
The clamp can also be used to cut narrow-stemmed Laser (sidewinder) keys.
The procedure is as follows:
1) open the clamps by loosening knobs (E) (E1).
2) place the stop bar into the groove (fig. 20).
3) insert the key so that it butts against the bar.
4) secure the key by tightening knob (E).
5) remove the bar and repeat the same operations on the right-hand jaw.
Cutting:
1) before activating the start switch (Q) lower lever (I) close to the keys and regulate the spring system
for laser (sidewinder) keys (ch. 7.5).
2) start the cutting operation by activating switch (Q).
3) lower the spindle, cut the key and stop at the beginning of the cut.
•
secure the spindle at this height by turning the lever (I) clockwise.
•
carry out the cuts using only lever (C).
Note: the letters in brackets refer to fig.4, page 10.
Fig. 20
bar
®
