ECODRILL 2000 CODE
Operating manual - English
22
8
CUTTING OPERATIONS
For complete safety during the cutting operations, take the following precautions:
•
Always work with dry hands.
•
Check that the machine is properly earthed.
•
Wear protective goggles even if the machine is provided with a safety shield over the cutting
tool.
•
Before starting the motor (switch Q), carry out the following operations:
a) place the keys in the clamps
b) install the tools and gauge them.
•
Keep hands away from the cutting tool in motion.
8.1
Fitting the keys
1) Switch on the machine with the master switch.
2) take the clamp carriage towards the operator.
3) place the original key into the left-hand jaw and the keyblank into the right-hand jaw, paying attention
to the type of stop on the key.
8.2
Cutting dimple keys
1) turn on switch (P) (fig.4, page 10).
2) install the cutter and tracer point and gauge.
3) release the tracer point spring (ch. 7.4, page 18).
4) grip the levers (C) and (I) (fig.4) cut the key, first centering the tracer point on the hole on the
original key then taking the cutting tool up to the keyblank.
8.3
Cutting the back
If cuts are to be made on the back, place the key in a vertical position.
Fig. 17
