IKUSI I-syon 70-M, User Manual

Page: 11 / 34

70-M USER’S MANUAL
70-M V1.1 (05/07) 120009-0D.pdf IKUSI se reserva el derecho de modificar esta información sin previo aviso.
8
70-M V1.1 (05/07) 120009-0D.pdf IKUSI reserves the right to modify this information without prior notification.
RECEIVERS
Proceed to connect the power supply and the output connections. Use the plug-in terminals and the
connection block diagram provide in this manual (page 11).
4. – TRANSMITTERS
4.1. – TYPES OF TRANSMITTERS
LED’s signalling in correct operating mode:
1) No radio link with the transmitter:
“Power”: solid green.
“Hard-OK”: solid green.
“Signal”: Blinking if there are transmitters near and
in the same band.
2) There is a radio link with the transmitter:
“Power”: solid green.
“Hard-OK”: solid green.
“Signal”: green blinking fast.
“Data”: green blinking fast.
“ID”: green blinking fast.
3) With STOP relay activated and active outputs:
“Power”: solid green.
“Hard-OK”: solid green.
“Signal”: green blinking fast.
“Data”: green blinking fast.
“ID”: green blinking fast.
“Relay”: solid green if the STOP relay is activated.
“Order”: green (variable intensity), if one or more PWM outputs are activated.
“Order”: green (fixed intensity), if at least one or more relay outputs are activated.
The models with LCD display are always required for Tele-Alignment purposes.
Generic : máx. 10 functions
(1 step) + ON/OFF (without
display)
Hoisting : máx. 6 functions
(2 steps) + 2 AUX: A1 and A2
(1 step) + START + ON/STOP
Hoisting : máx. 6 functions
(2 steps) + START +
ON/STOP (with display).
REMOTE PROGRAMMER
Hoisting (Cat. 3 EN-954-1) : máx. 4
functions (2 steps) + START +
ON/STOP (without display)
T70MG10 T70MH3 T70MH3D T70MH2