70-M USER’S MANUAL
70-M V1.1 (05/07) 120009-0D.pdf IKUSI se reserva el derecho de modificar esta información sin previo aviso.
4
70-M V1.1 (05/07) 120009-0D.pdf IKUSI reserves the right to modify this information without prior notification.
2.- SAFETY INSTRUCTIONS
2.1.- GENERALS
These instructions must be read carefully. This will allow you to install, use and maintain
this device in a proper state, reducing the risk of incorrect use.
Do not install the equipment in machines for the elevation of people or in explosive
atmospheres.
Any failure to comply with that set out in this manual will create a hazard, for which
reason the following must be respected:
¾
Ensure that the installation is carried out by trained, competent staff.
¾
The safety rules of the work area and of all competent authorities must be respected every
time.
¾
Ensure that this manual is permanently available to the operator and to the person in charge
of maintenance.
¾
Keep the transmitter out of the reach of unauthorised people.
¾
At the start of each day, check the correct working of the STOP button and the other safety
devices of the machine.
¾
In the event of any anomaly, use the STOP button.
¾
If there are several radio remote systems working in the same area, ensure that the used
transmitter corresponds to the machine that is being controlled. Identify the machine which
the transmitter corresponds to.
¾
Carry out regular checks and preventive maintenance.
¾
In the case of repairs, only use original spare parts.
¾
Never modify the device without prior study and approval of the manufacturer.
¾
Never use the device with a power supply other than the indicated.
¾
Never allow the device to be used by unqualified people.
¾
After being used, do not leave the transmitter in service without having pressed the STOP
button in order to prevent accidental operations.
¾
Do not use the device without visibility.
¾
Avoid knocking or dropping the set.
¾
Do not use the set if failure is detected.
2.2.- HOISTING MACHINES
¾
Ensure that the machine is fully halted throughout the estimated assembly time; clear the
work area and use safety clothing.
¾
In the case of overhead cranes, park the crane and position stop-ends (if these are not
available use appropriate signs) at a suitable distance in order to prevent collision with other
cranes in the same area.
¾
Verify the power supply and turn off the main contactor.
¾
Remember that the receiver has at least, more than one circuit under voltage.
¾
Even if the power supply is disconnected, there is still a risk of electrical discharges.
¾
Never forget to connect the ground cable.
¾
Use fireproof cables for the electrical connections.
¾
Check that the input power supply corresponds to the right voltage of the receiver.
¾
Be cautious: it may occur that the equipment has not been connected properly, which can
result in unforeseen movements during the start-up.
Summary of Contents for I-syon 70-M
Page 2: ...70 M ENGLISH ...