Ikra ICMT 2/20, Original Instructions Manual

Page: 50 / 92

50
Check all nuts, bolts, and screws at frequent intervals
for security to ensure the machine is in safe working
condition. Any part that is damaged should be properly
repaired or replaced by an service station.
Is the device or power cord from the battery charger
immediately damages the power plug or battery pull.
Repairs may only be carried out by an authorized
Specialist company. By improper Repairs can pose
significant risks to the user arise.
Warning! Always remove the battery before checking and setting work.
Replacing the guide bar and saw chain
WARNING
Wear protective gloves.
A dull or improperly sharpened chain can cause
excessive motor speed during cutting which may
result in severe motor damage.
Failure to replace or repair a damaged chain can
cause serious injury.
The saw chain is sharp. Always wear protective
gloves when performing maintenance to the chain.
Maintenance plan
Daily check
Bar lubrication Before each use
Chain tension Before each use and
frequently
Chain sharpness Before each use, visual
check
For damaged parts Before each use
For loose fasteners Before each use
Chain brake function Before each useInspect
and clean
Guide Bar Before each use
Complete saw After each use
Replacement parts
Spool 78001921
Blade 73040106
Chain 91P033X
Guide Bar 080SDEA318
Chain must be fitted with bar from the same
manufacturer according to above combinations.
DISPOSAL
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
Please dispose of the device itself at an according collec-
ting/recycling point. By doing so, plastic and metal parts
can be separated and recycled. Information concerning
the disposal of materials and devices are available from
your local administration.
Batteries are not to be put into the rubbish. As a consu-
GB ENGLISH
Troubleshooting
Check the battery capacity. A low charge level may result in more blockages. Continue working with the battery
fully charged.
The following table shows error symptoms and describes how you can remedy them if your machine is not wor-
king properly. If this does not allow you to locate and correct the problem, contact your service workshop.
Cause Error Remedy
Telescopic hedge trimmer is not
working
Battery is empty See “Charging the battery”
Battery is defective Have it replaced by our
technical service
Telescopic hedge trimmer is
working irregularly
Internal loose contact Visit a specialist workshop
On/off switch is defective Visit a specialist workshop
Cutting blade runs hot Too much friction due to too
little lubricant
Apply lubricant spray
Poor cutting performance /
unclean cut
Blunt cutting blade Sharpen/replace cutting blade