2244
Wing Nut
Ball Clamp
Strobe
Mount
Release Button
Stem
Release Handle
Ikelite
Substrobe
Ball Socket
Ball
Clamp
Wing
Nut
Ball
Socket
2233
M
MO
OU
UN
NTTIIN
NGG TTH
HEE SSTTRRO
OBBEE
IIKKEELLIITTEE AARRM
M SSYYSSTTEEM
MSS ______________________________________________________________________________________________
Ikelite offers several arm choices compatible with the DS125. The arm is NOT
supplied with the strobe unless purchased as part of a complete package.
Ikelite arm systems are designed for underwater use and may not hold the
adjustment ABOVE WATER due to the weight of some large strobes. Be careful when
transporting the system since some camera trays may not be able to support the weight
of the strobe above water.
The strobe will feature either a paddle-type or ball-type mount on the underneath
side. Please read the following arm sections for additional information.
S
STTRRO
OBBEE AARRM
M #
#44007755..11
The versatile Ikelite Strobe Arm offers multiple aiming positions. A second arm
section with second joint can be added if desired, #4076.2
M
MO
OU
UN
NTT SSTTRRO
OBBEE TTO
O AARRM
M ________________________________________________________________________________________
The paddle-type strobe mount may be featured on the DS125 and secures to most
Ikelite arm systems. The paddle-type mount is required for compatibility with the arm
4075.1 and it allows the strobe to tilt forward and backward. The rubber gasket on the
strobe mount creates friction against the arm and should NOT be lubricated.
Remove wing nut from strobe mount. Place the top of the arm against the rubber
gasket on the strobe mount. Replace the wing nut and tighten to secure. This
adjustment allows the strobe to pivot at the top of the arm. Rubber gasket creates
friction to hold the adjustment underwater and should NOT be lubricated.
M
MO
OU
UN
NTT AARRM
M TTO
O H
HO
OU
USSIIN
NGG ____________________________________________________________________________________
The stem protruding at the base of the arm snaps into the release handle on the
Ikelite housing. The stem also provides a convenient location for securing the optional
DS Slave Sensor or EV-Controller.
Insert the stem into the release handle. Depress the handle's release button and slide
the stem fully into the receptor. Release the button and it should spring back to the
original position locking the arm in place.
AAIIM
M TTH
HEE SSTTRRO
OBBEE________________________________________________________________________________________________________
Loosen the large four-lobed knob on the knuckle and insert the arm tube. The arm
can be rotated 360°, pivoted sideways, and also rotated forward and backward before
retightening the knob.