Ikegami OCP-100, Operation Manual, Page: 33 / 46

3.6 Panel Confi g function
● Setting screen display
PANEL
ENABLE
MASTER
VF
POWER
HEAD
LINK
COLOR
/
PAGE PM IND
ENG FILE
LOAD
SKIN HUE QUICK START AWB ABB
CAP BARS CAL SUPER V
SUPER KNEE MATRIX
F
2
F
1
ON VAR.
HOLD MENU
BLK STRETCH
1 2 3 L H M
ON
+ 3 + +
3 7 11 3 7 11
（ % ）
GAMMA
C.TEMP
VAR.
GAIN （ dB ）
DTL
SOFT
DTL
SKIN
SHUTTER
ON
MODE SWITCH
AUTO SETUP
HEAD
CCU
OPT LEVEL
POWER
CAM
POWER
LENS EXT
RANGE SENS
OPEN
FULL
±1 ±2
OPEN SHORT
CABLE
ALARM CALL
IRIS
PED
ENC R
G
Y
B RGB
MON SEL
CLS
OCP
-100
IRIS
KNOB FREE
By simultaneously pressing down the switches,
the Panel Config will be displayed.
Setting Value
Display
Item Display
Switchover of
Settings
Switchover of
Items
- While the Menu is not displayed, press the PM IND switch for about 1 second while pressing the KNOB FREE switch.
After 1 second has elapsed, the OK sound will be generated and the STR number will be displayed.
- By operating the UP/DOW switch located on the side of the Display, items or settings can be altered.
- By operating the left and the center UP/DWON switch, the Setting Item will be switched over.
- By operating the right UP/DOW switch, the Content of the Setting will be switched over.
●
STR number of display
- When the setting screen of the Panel Con
fi
g function is displayed, the STR number is displayed for about 2 seconds.
- The STR number display is carried out by using the 4-digit Display at the center.
Ex : In the case of STR-0123V45.67.89, the number will be played in the sequence of “0123” “V45” “6789”.
- If the UP/DOWN switch for switching of Items or Settings is operated while the STR number is displayed, the STR number
display will disappear and the Panel Con
fi
g setting will be displayed. (At this time, no change will occur in the contents of the
settings.)
●
RAM Clear
- If the UP/DOWN is pressed upward while the setting of the last item on the List of Con
fi
gurable Items is displayed, the display,
“RAM” “CLR” “RDY”, will appear.
- “RDY” can be switched over to “EXE?” by operating the UP/DOWN switch on the right side.
- The KNOB FREE Switch Lamp will blink when “EXE?" Is displayed and will go off when “RDY” is displayed.
- If the KNOB FREE Switch Lamp is turned off, the switch is operating normally.
- If the blinking KNOB FREE switch is pressed, the display, “RAM” “CLR” “....”, will appear, causing the RAM Clearing
sequence to proceed.
- When RAM clearing is completed, “COMP” “LETE” “!!!!” will be displayed, indicating that the Initialization has been
completed.
- After 1 second since the completion of the Initialization, the display will be changed to “OCP” “REST” “ART !”. Then, 2 seconds
later, the Panel will automatically restart.
3. OPERATION 3-13
OCP-100 1209 VOL1 (U) (E) OCP-100