Ikegami OCP-100, Operation Manual

Page: 15 / 46

23 MONITOR SELECT switch
Used to select the Picture Monitor (PM) or Waveform Monitor (WFM) output signals. The table below shows the output
signals corresponding to each signal position.
Switch Position R G B RGB Y ENC
PM R G B R+G+B Y ENC
WFM R G B SEQ Y ENC
24 KNOB FREE switch
While this switch is pressed, each VR control (DTL/SKIN, C. SAT/GAMMA, KNEE PT/SLOPE, R/G/B GAIN, R/G/B
BLACK) (see item 12), the IRIS, M-PED control (see item 15), and the IRIS RANGE control (see item 20) are freed, and
the control data is maintained even if these controls are turned. When any of these controls become one-sided as a result of
running an auto process or parallel control at the MCP, the one-sided control can be corrected by setting the control to the
center position while holding down the KNOB FREE button.
25 LENS EXT indicator
Lights up when the lens extender is ON.
26 TALLY indicators
R TALLY and G TALLY indicators. The R TALLY also lights up when the CALL switch of the camera head or BS is pressed.
27 PS CONT connector
Connector for POWER REMOTE control. When connected to the BS with the POWER CONT cable, the MAIN POWER can
be controlled from the OCP.
28 COLOR LINK connectors
Connect the COLOR LINK cable. Bridge-connecting multiple OCPs with the COLOR LINK cables enables color link
operation.
29 COMMAND connector
Connect the CP cable.
30 PREVIEW connector
Output connector for the PREVIEW switch (see item 15).
1. NAME and FUNCTION 1-7
OCP-100 1209 VOL1 (U) (E) OCP-100