IKA MINISTAR digital, Manual

Page: 10 / 13

24
Commissioning
/// Start-up
Secure the device to a stable stand with a cross sleeve.
The stirring vessel must always be securely fixed for safety reasons. You must also ensure
that the mounting device (stand) is set up in such a way that it is not liable to topple and
does not start to move during the stirring procedure.
If these conditions have been met, the machine is ready for operation when the mains
plug is plugged in. If these conditions are not met, safe operation is not guaranteed and
the machine could be damaged.
Observe the ambient conditions (temperature, humidity, etc.) listed under “Technical Data”.
The AC adapter is suitable for 100 VAC to 240 VAC.
Switching on/off:
1.
After connecting the power to the device or touching the standby key
(A)
more than 1
second, the device is switched on. Following screens appear:
2.
After that, the following screen appears automatically.
25
Maintenance and cleaning
/// Cleaning
The device is maintenance-free. It is only subject to the natural wear
and tear of components and their statistical failure rate.
For cleaning disconnect the main plug!
Use only cleaning agents which have been approved by IKA to clean IKA devices.
Dye isopropyl alcohol
Construction material water containing tenside / isopropyl alcohol
Cosmetics water containing tenside / isopropyl alcohol
Foodstuffs water containing tenside
Fuel water containing tenside
Dirt Cleaning agent
For materials which are not listed, please request information from
IKA application support. Wear protective gloves during cleaning the devices.
Electrical devices may not be placed in the cleansing agent for the purpose of
cleaning. Do not allow moisture to get into the device when cleaning. Before
using another than the recommended method for cleaning or
decontamination, the user must ascertain with IKA that this method
does not destroy the device.
/// Spare parts order
When ordering spare parts, please give:
› machine type
› serial number, see type plate
› item and designation of the spare part,
see www.ika.com , spare parts diagram and spare parts list
› software version
3.
Then, the device is ready for operation.
4.
After switching off the device by touching the standby key ( A ) more than 1 second,
following screen appears:
Software version
Self test screen
Device identification
Last speed setting
Setting speed:
› Ensure the speed set is suitable for the test medium selected. If in doubt, set the speed
to the lowest speed (counterclockwise direction) by rotating the control knob (C) . Press
the control knob
(C)
to start or stop the stirring. During running, the standby LED blinks
to indicate the running status.
Standby LED