/// Repair
Please send in device for repair only after it has been cleaned and is free
from any materials which may constitute a health hazard.
For repair, please request the “Decontamination Certificate” form IKA or use the
download printout of it from IKA website:
www.ika.com
.
If you require servicing, return the device in its original packaging. Storage packag-
ing is not sufficient. Please also use suitable transport packaging.
27
E 4
Cause
› motor blockage or overload
Effect
› motor off
Solutions
› disconnect the device from the power supply
› decrease the load on the motor and restart device again
E 8
Cause
› speed sensor fault or overload
Effect
› motor off
Solution
› disconnect the device from the power supply
If the actions described fails to resolve the fault or another error code
is displayed then take one of the following steps:
› Contact the service department.
› Send the device for repair, including a short description of the fault.
E 2
Cause
› hardware driving error
Effect
› motor off
Solution
› contact the service department
E 3
Cause
› temperature inside of the device is too high
Effect
› motor off
Solution
› switch off the device and allow it cool down
Error code | Cause | Effect | Solution
Error codes
/// Troubleshooting correctly
If an error occurs, the fault is shown by an error code on the screen.
Proceed as follows in such cases:
› Disconnect the device from the power supply.
› Carry out corrective measures.
› Restart device.
26
Summary of Contents for MINISTAR digital
Page 1: ...MINISTAR digital...
