36 Error
codes
Err. 02
Cause
› hardware driving error
Effect
› motor off
Solution
› contact the service department
Err. 03
Cause
› temperature inside of the device is too high
Effect
› motor off
Solution
› switch off the device and allow it cool down
Error code | Cause | Effect | Solution
/// Repair
Please send in device for repair only after it has been cleaned and
is free from any materials which may constitute a health hazard.
For repair, please request the “Decontamination Certificate" form from IKA
or download a print version from www.ika.com.
If you require servicing, return the device in its original packaging. Storage
packaging is not sufficient. Please also use suitable transport packaging.
Error codes
/// Troubleshooting correctly
If an error occurs, the fault is shown by an error code on the screen.
Proceed as follows in such cases:
› Disconnect the device from the power supply.
› Carry out corrective measures.
› Restart device.
Error
codes
37
Err. 04
Cause
› motor blockage or overload
Effect
› motor off
Solutions
› disconnect the device from the power supply
› decrease the load on the motor and restart device again
Err. 05
Cause
› vibration of the device is higher than the permitted value
Effect
› motor off
Solutions
› disable the vibration dectection
› Make adjustments to correct the conditions causing
the excessive vibrations.
Err. 06
Cause
› the device fall from assembly
Effect
› motor off
Solutions
› disconnect the device from the power supply
› secure the device to the stand correctly
Err. 08
Cause
› speed sensor fault or overload
Effect
› motor off
Solution
› disconnect the device from the power supply
If the actions described fails to resolve the fault or another error code
is displayed then take one of the following steps:
› Contact the service department.
› Send the device for repair, including a short description of the fault.
Summary of Contents for MICROSTAR 15 control
Page 1: ...MICROSTAR control...
