Pressing the +/- buttons
(H
or
I)
increases or reduces the
temperature.
RT
The heating function is started and stopped by pressing the
„Temp“ button
(J)
.
Function Heating
ECO mode
RO/RT
The heat generated in the device can be reduced by lowering the
power of the input coils.
Pressing the „ECO Mode“
(F)
key reduces the current power
setting. ECO mode is indicated by an “E” preceding the speed.
When the power is set to ECO mode, the speed is limited to
600 rpm.
RO/RT
The
(G)
key activates the “Reverse Rotation” function.
When the „Reverse Rotation“ function is switched on, a decimal
point
(K)
appears in the LCD display.
The running time (30, 60, 90 or 120sec) is set by pressing the
(G)
key followed by the +/- keys.
After the preset running time, the drive is switched off and
restarted at minimum speed in the opposite direction after a
pause specific to the speed.
In this way the magnetic rod is captured and any liquid still
rotating is gradually slowed down. Then the drive accelerates to
the target speed.
Note: If the “Reverse Rotation” key
(G)
is pressed again, the drive
will keep rotating in the same direction.
When the device is started up again, the drive will rotate in the
direction last set.
Direction of rotation reversal
RO/RT
To toggle between modes, press the Start/Stop key (C) when
switching on.
Operating Mode “A”
All the parameter settings are retained when the device is
switched off or disconnected from the mains.
The “Start/Stop”
(C)
key starts the device with the set parameters.
Operating Mode “B“
All parameter settings, including “Start/Stop”, are saved when the
device is switched off.
Factory setting: mode A
Operating modes
The equipment is maintenance-free. It is only subject to the natu-
ral wear and tear of components and their statistical failure rate.
Cleaning
For cleaning disconnect the main plug..
Use only cleansing agents which have been approved by
IKA
to
clean devices.
Use to remove:
Dyes
Isopropyl alcohol
Construction materials water containing ten side / isopropyl alcohol
Cosmetics
water containing ten side / isopropyl alcohol
Foodstuffs
water containing tenside
Fuels
water containing tenside
- Do not allow moisture to get into the appliance when cleaning.
- Wear protective gloves when cleaning the devices.
- Please consult with
IKA
before using any cleaning or deconta
mination methods, other than those recommended here.
Maintenance and cleaning
Ordering spare parts
When ordering spare parts, please give:
- Device type
- Manufacturing number, see type plate
- Software version
- Item number and designation of the spare part,
see
www.ika.com
.
Repair
The device must be clean and free from any materials which may
constitude a health hazard when sent for repair.
Use the „certificate of compliance“ included or download the
form from the IKA
®
website
www.ika.com
.
Please return the appliance in its original packaging. Storage
packaging is not sufficient for returns. Please also use suitable
packaging for transportation.
12
