English
19
8.3 Scene Store
To store a scene:
• Press the SCENE button for more than two seconds and the SCENE button will start flashing.
• All pads already containing a scene will illuminate GREEN.
• The backlight on all empty scene will be off.
• The pad with the in-use scene will illuminate ORANGE.
• Press the pad number of the pad you’d like to use to store the scene.
• The pad that has been pressed will quickly flash (RED) two times to confirm the scene has been stored.
• iRig Pads will automatically exit SCENE mode (SCENE button will turn off).
The same operation can be done on both empty or existing scenes. In this case the previous scene will be
overwritten. This is also valid for Factory scenes.
8.4 Scene erase
To delete a scene:
• Press SCENE or keep SCENE pressed to enter in the SCENE LOAD or SCENE STORE modes (either
modes will let you delete scenes).
• Press and hold the pad that’s storing the scene you’d like to delete for more than two seconds.
• The pad will turn off to confirm the scene has been deleted, and the pad light will then go off.
• iRig Pads will NOT automatically exit SCENE mode to allow for further operations (like save or load).
8.5 Factory Restore
Press the SCENE and FIX VEL buttons while powering up iRag Pads to return the device to its factory presets.
NOTE: Be aware that performing a Factory Restore will delete any programming that has been done on all
scenes.
9 FIX VEL button
This is a toggle ON-OFF switch that lets all pads send a fixed velocity when enabled.
Pressing FIX VEL will make the button turn RED. In this case, the pads will always send a velocity of 100.
Pressing FIX VEL again will make the button’s backlight turn off, and all pads will send a velocity value
proportional to the playing velocity on the pads.