10
CLEANING FLOORS WITH THE
WET
VAC
USING YOUR
WET
VAC
1:
Press the (Power Icon) button to turn the vacuum on. It will start in ECO mode by default.
2:
Press the (Max/Eco button) to toggle between suction modes.
3:
Choose a location to start cleaning. Hold the spray button for around 3-5 seconds to prime the roller
before the first pass. Use the trigger as needed during the cleaning cycle.
NOTE:
Be sure to keep the roller brush
flat on the ground as shown.
FOR BEST RESULTS:
•
Use on hard surfaces such as tile and sealed hardwood floors. Use on rough surface may impact
wet suction performance.
• Do not recline the vacuum more than shown in the image below.
• Avoid over watering.
• Avoid vacuuming foamed liquid as that may inadvertantly trigger the Dirty Tank Full sensor.
•
Do Not turn the vacuum upside down as dirty water may flow into the motor assembly and damage the
appliance.
• At the end of each cleaning cycle please carefully follow the instructions for self cleaning and tank
maintenance.
• Pass as many times as needed to remove the mess/debris.
•
For faster drying floors, pass without holding the spray trigger.
2
1
3
Flat to the ground
Summary of Contents for iHWV5
Page 2: ......
