7
Using The Remote Control Unit
Install/Replace the Remote Control Battery
Battery Compartment
Pressing
FWD/REV
while iPod is inserted will
FWD/REV
to next/previous track
Pressing and holding
FWD/REV
while iPod is docked will scan forward/reverse
within currently playing track.
Pressing
Play/Pause
from power off mode will play iPod.
Pressing
Play/Pause
while iPod is docked and playing will pause iPod.
Press again to resume play.
Power
Button turns unit ON and OFF
Remote not included
with all iH41
models.
To order a remote,
please visit
www.ihomeaudio.com
Volume
Buttons raise and lower volume on the unit.
Install/Replace the Remote Control Battery (for models with remote control)
To order a remote control, visit www.ihomeaudio.com
The remote control battery is already installed at the factory. When the remote
control stops operating or its range seems reduced, replace the battery with a
new one.
1. The battery door is located on the back end of the unit.
2. Slide the battery door to release the battery door latch and remove the battery
door.
3. Insert a “CR2032” 3-volt lithium battery. Make sure the polarity (the + and –
side of the battery) is correct.
4. Replace the battery compartment door back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
Pressing the
mute
button will mute the unit. While unit is muted
the volume dislpay will flash. Pressing
mute
again or volume up
or down will unmute.
The
up
,
down
,
fwd
,
rev
,
menu
and
enter
buttons are used for iPod
menu navigation
The
shuffle
and
repeat
buttons will activate/deactivate the iPod’s
shuffle
and
repeat
modes
The
snooze
button works exactly same as on main unit.
