IHI Shibaura G-EXE22-OMEGA-S9, Operator'S Manual

Page: 83 / 106

When the work roller is not used
When the work roller is used
Turn the knob one-half turn
Front roller
Lower
Clockwise direction
Adjustment knob
Blade height gauge
Align the neck of the screw
with the top of the lower blade.
Work roller
Anchor screw
Clockwise direction
Work roller
Align the end
of the screw
with the end
of the rotor.
Blade height gauge
6. Place the cutting height gauge against the portion of the
front roller that contacts the ground and the rear roller,
and then turn the height adjustment knob for the front
roller until the neck of the screw in the center of the gauge
is at the same height as the top of the lower blade.
!
Turn the height adjustment knob for the front roller clock-
wise to lower the front roller and counterclockwise to raise
the front roller.
7. Adjust the height on the left and right sides. Once the
lower blade is positioned at the correct height, tighten the
height anchor nuts to anchor the height of the front roller.
8. Loosen the height anchor nuts on the work roller height
adjustment knobs (left), (right).
9. Place the cutting height gauge against the portion of the
front roller that contacts the ground and the rear roller,
and then turn the height adjustment knob for the work
roller until the length of the gauge screw sticking out is the
same as the end of the work roller.
!
Turn the height adjustment knob for the work roller clock-
wise to raise the work roller and counterclockwise to lower
the work roller.
10. Adjust the height on the left and right sides. Once the
work roller is positioned at the correct height, tighten the
height anchor nuts to anchor the height of the work roller.
■ Adjusting the work roller
!
When not using the work roller, you can raise it approxi-
mately 5mm.
!
Loosen the left and right height anchor nuts, and then
turn the work roller knob a half turn to raise it and place it
in the position shown in the figure when the work roller is
not being used.
!
Adjust the height of the work roller to the position "When
the work roller is used" as shown in the figure.
Adjustments
29