IGNIA LIGHT onled, Installation And Maintenance Manual

Page: 3 / 16

3
Fixed colour: Selection of a fixed colour among twelve possibilities.
COLOUR Nº COLOUR COLOUR Nº COLOUR
1 Red 7 Pale violet
2 Green 8 Sky-blue
3 Blue 9 Orange
4 Yellow 10 Pink
5 Cyan 11 Emerald green
6 Magenta 12 White
Automatic sequence of colours: Selection of eight colour sequence programmes. Each programme is defined by the
lighting time of each colour and the transition time from one colour to another according to the following table:
SEQUENCE ORDER OF COLOURS
1 Red Green Blue
2 Cyan Magenta Yellow
3 Green Esmerald green Cyan Sky-blue
4 Red Orange Green Orange
5 Red Pink Blue Pink
6 Red Orange Green Cyan Blue Pink
7 Pale violet Magenta Cyan Yellow White Yellow Cyan Magenta
8 Red Green Blue Yellow Cyan Magenta Pale violet Sky-blue Orange Pink Esmerald green White
3. SAFETY WARNINGS:
• If the cable or wiring of this luminaire becomes damaged, it may only be replaced by the manufacturer or one
of its service engineers, or a person with a similar qualification, in order to avoid any accidents.
• The light source of this luminaire is not replaceable; when the light source reaches the end of its service life
the whole of the luminaire must be replaced.
• The persons who are in charge of assembly should have the required qualifications for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed. WIRING IN BUILDINGS. SPECIAL WIRING. SWIM-
MING POOLS.
• In this respect, for QuadraLED models it must comply with IEC 364-7-714: ELECTRICAL INSTALLATIONS OF
BUILDINGS. OUTDOOR LIGHTING INSTALLATIONS.
• Any operation related to the maintenance or replacement of parts should be performed with the floodlamp
disconnected from the electric power system.
• The lamp is designed TO BE USED ONLY SUBMERGED IN WATER and TO OPERATE ONLY WITH A SAFETY
TRANSFORMER.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric
components which have been inserted or handled at locations other than its own premises.