Igloo ELBA, User Manual

Page: 11 / 32

en
11
User manual Elba www.igloo.pl
3.2. Connection and actuation
• Unpack the device and remove the protective foil and cardboard sections
• Place the display cabinet on an even basis, which is hard enough, and then level it with feet Fig.1/4 (p.13)
• If the user shall obtain a device partially disassembled to secure it during transportation, perform the following
operations:
I. Fix shelf grips in perforated frame strips Fig.2/1; 2 (p.11)
II. Place grid shelves on
fi xed grips Fig.2/3 (p.11)
• Place the plug of the connecting cable directly in plug-in socket (it is forbidden to connect the device by means of
extension cords or dividers!)
• Turn the main switch on Fig. 3/1 (p.11), which will activate the thermostat, and then the aggregate of the device.
• Set the temperature on the temperature regulator panel Fig 3/3 (p.11) (service details on p.16)
• Turn on the lighting switch Fig. 3/2 (p.11)
Fig.2 Mounting perforated shelves
1 – Perforated frame strip
2 – Shelf
fi xing grip
3 – Plasti fi ed grid shelf
4 – Price strip of the shelf
Fig.3 Control panel
1 – Main switch (turns on/ off the aggregate of the device)
2 – Illumination switch
3 – Thermostat panel (temperature regulator)
(service details in Chapter No. 7 on p.16)
4. EXPLOITATION
Temperature of cooled space and operating cycle of the aggregate may vary. It depends on numerous factors, such as
temperature of the surroundings and amount and temperature of products placed in the device. It is recommended to
avoid unnecessary opening of the doors.
The device should be placed in a dry place, not insolated and well ventilated, ensuring proper air circulation (min. 10
cm distance between the wall and the device), far from sources of heat and devices forcing the air circulation (roof ad
mobile ventilators, blowing heaters). The device operates properly in an environment, where temperature falls within
proper climate class stated on the data plate. The operation of the device may worsen, when it will operate in tempera-
ture higher or lower than the one determined in the stated temperature range.
• The fi rst cleaning of the device should be provide right after unpacking, and before turning it on. The unit should
be cleaned with water at a temperature not exceeding 40°C with a neutral detergent. For washing and cleaning
the equipment it is prohibited to use products containing chlorine and sodium varieties, which destroy the protecti-
ve layer and components of the device! Any residue of adhesives or silicone on metal elements should be remo-
ved only with extraction naphtha (not applicable to items made of plastic !). Do not use other organic solvents.
When cleaning the unit is prohibited to use water jet. The unit should be cleaned with a wet rag.
After installation of the device at the destination place it should be left to rest for at least 2 hours before
turning it on (for devices with built in compressor) to set the level of refrigerant in order to prevent problems
with starting up the aggregate.
WARNING: Keep out the cooling circuit from damage!
1 2 3
1
2
3
4