12
9 Parameter setting
During parameter setting the unit remains in the operating mode� It continues
to monitor with the existing parameters until the parameter setting has been
completed�
9.1 Parameter setting in general
3 steps must be taken for each parameter setting:
1
Select parameter
►
Press [Mode/Enter] until the
requested parameter is displayed
.
2
Set parameter value
►
Press [Set] and keep it pressed�
> Current setting value of the
parameter flashes for 5 s�
> After 5 s: setting value is changed:
incrementally by pressing the button
once or continuously by keeping the
button pressed�
Numerical values are incremented continuously� For reducing the value: let the
display move to the maximum setting value� Then the cycle starts again at the
minimum setting value�
3
Acknowledge parameter value
►
Briefly press [Mode/Enter]�
> The parameter is displayed again�
The new setting value is saved�
Setting of other parameters:
►
Start again with step 1�
Finishing the parameter setting:
►
Press [Mode/Enter] several times until the current measured value is displayed or wait
for 15 s�
> The unit exits the parameter setting mode�
• If [C�Loc] is displayed when an attempt is made to modify a parameter value,
parameters are read or written via the IO-Link interface (temporary locking)�
• If [SLoc] is displayed when an attempt is made to modify a parameter value,
the sensor is locked via software� This locking cannot be removed on the
sensor but unlocking has to be made via the IO-Link interface�
