6.2
P
ERIODIC
M
AINTENANCE
P
ROCEDURES
6.2.1 Removing Dust From the Printer Mechanism
WARNING
To carry out this operation, IER recommends that you
only use the can of compressed air supplied with the
cleaning kit, since it has been tested and approved as
non-flammable and non-explosive.
IER will not accept responsibility for problems arising
from the use of any other product.
DO NOT USE THE DUSTER CAN IF THERE IS VERY
LITTLE AIR LEFT. THE CAN MOSTLY CONTAINS
PROPELLENT, WHICH IS HIGHLY FLAMMABLE.
Use the duster can supplied with the IER Cleaning Kit, following
the safety precautions on the can and those mentioned above,
dislodge any paper chaff and dust in the printer by blowing air into
the following zones:
Arrow #5: inside the two paper guides,
Arrow #4: under the two paper guides and the print mechanism,
Arrow #3: at the end of the paper path around the media sensor
Arrows #2: on the platen, to the document separation mark
sensors and behind the printer front panel, where the optional
cutter is installed,
Arrows # 1: in the output slot in the front panel.
IER 400B
User Guide
Page 46
N0C402B Rev. 1
July 6, 2009
Ce document est la propiété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated without prior written authorization