IEMCA BOSS 332, Manual For Use And Maintenance

Page: 125 / 211

EN
6 - USE AND OPERATION BOSS 332/545/552 HD
6 - Pag. 6 / 24
16 Multifunction
- Sets the numerical value.
- Opens the guide channels.
- Push both start buttons and then the key;
release both buttons and the key only when
the movement is finished.
17 Moves the bar pusher at high speed.
18 Sets the carriage movement motor.
During the daily use of the bar feeder this
function must never be used.
19 Multifunction
- Sets the numerical value.
- Moves the bar pusher at a low speed.
20 Resets the "BAR FEEDER ZERO SETTING" of the
carriage.
Hold down both start buttons and then the
key; release both buttons and the key when
the carriage starts moving towards the "BAR
FEEDER ZERO SETTING" position.
21 Multifunction
- Sets the numerical value.
- Closes the guide channels.
Push both start buttons and then the key;
release both buttons and the key only when
the movement is finished.
22 Multifunction
- Sets the numerical value.
- Recalls the main menu (MAIN MENU).
23 Multifunction
- Sets the numerical value.
- Recalls the selection cursor.
24 Multifunction
- Stops the selection function.
- Restores the value prior to the non-confirmed modification.
25 Confirms the entered data.
26 Sets the comma.
27 Bar feeder start button (green light): press the button to start the bar feeder and hold it
down until the button lights up.
28 Bar feeder stop button (red light): press this button to stop the bar feeder and reset the
"Errors".
29 Remnant detection disabling button (white light)
Press the button to feed a "new" bar without the detection of bar remnant in the bar pusher
collet.
30 Half-bush opening and closing button (white light)
- In "Manual" mode, when the bar feeder is in the required position, the half-bushes will
close when this button is pressed. If pushed again, the half-bushes will open.