IEMCA BOSS 332, Manual For Use And Maintenance, Page: 135 / 211

EN
6 - USE AND OPERATION BOSS 332/545/552 HD
6 - Pag. 16 / 24
6.5.3 Automatic cycle start
• Power the lathe on.
• Turn the main switch to position I (ON).
• Press [pupa_boss_barra] to start the bar feeder.
• Press to select the manual mode.
• Carry out a "bar feeder zero setting" in the
following way:
press the start buttons and if the upper guide
channels are not closed, the bar feeder will not
perform the "BAR FEEDER ZERO SETTING";
messages will be displayed about the operations to
carry out to bring the upper guide channels to the
required position.
After carrying out the required operations, press
the start buttons and .
• Enter the parameter values (refer to the "Keyboard Instruction Manual").
• Press to bring the bar fore end near the cutting tool.
To start machining, press , when the lathe collet is closed. From now on, you will
obtain automatic bar feeding until bars are ended or according to the set program.
• During machining, empty the remnant recovery box. Remove the box after lifting it over the
tank edge.
WARNING – CAUTION:
do not manually lift loads with weights exceeding those foreseen by the
applicable regulations in force.
WARNING – CAUTION:
keep hands out of remnant drop area after the remnant box has been pulled off.
WARNING – CAUTION:
wear personal protections according to the regulations in force.
Place the box back under the remnant outlet.