IEMCA BOSS 332, Manual For Use And Maintenance

Page: 109 / 211

EN
5 - ADJUSTMENTS AND SETTING-UP BOSS 332/545/552 HD
5 - Pag. 24 / 34
5.3.2 BAR PUSHER REPLACEMENT PROCEDURE
WARNING - CAUTION
Never perform the following procedure when a bar is detected in the bar pusher
collet!
The replacement of the bar pusher, for a working cycle change or maintenance, may be
performed as follows:
- set the bar feeder to manual mode , with close guide channels;
- press and hold to start the automatic procedure, which allows the bar feeder to move
to the appropriate condition for the bar pusher replacement.
- In particular, by pressing , the bar pusher is positioned past the clamp device, the
guide channels open, the bar pusher moves to the completely backwards position and the
bar drop control devices are lifted allowing for the bar pusher removal.
INFORMATION
If during the above mentioned operations is released, the procedure will
stop. By pressing the button again, the procedure will start from where it was
paused.
NEW BAR PUSHER INTRODUCTION
WARNING – CAUTION:
Introduce the bar pusher correctly into the first feeding carriage housing.
- Close the bar feeder guard, reset the start button , enter in manual mode and
press to move the bar pusher forwards until the clamp position is exceeded of at least
200 mm.