PEB-7605 Series User’s Manual
15
CPU fan connector CPU Installed
(Rear side)
Note: ( 1 ) Make sure the CPU fan and heat sink assembly and the CPU top surface are in total contact to
avoid CPU overheating problem that would cause the system to hang or unstable.
(2)The PEB-7605 (On-Board PCU) no need it , which it already have CPU heat sink for fan less.
3.1.3 Main Memory
PEB-7605 SERIES provides 1 DIMMs (184-pin Dual In-line Memory Module) to support 2.6V DDRAM (Synchronized
DRAM) as on-board main memory. The
maximum memory size is 256B~ 1GB with using 256MB/512MB/1GB technology. Supports up to 1 double sided DIMMs at
266/333 MHz. The memory architecture adopts 128-bit data interface to support for x8 and x16 DDRAM(DDR1) device width.
In addition, it only support Non-ECC memory .
For system compatibility and stability, don’t use memory module without brand. You can also use the single or double-side
DIMM .The three DIMMs can be out of order. You can install different size of DDRAM module on DIMM1, or all to boot up
system.
Without out the contact and lock integrity of memory module with socket, it will impact on the system reliability. Follow
normal procedure to install your DDRAM module into memory socket. Before locking, make sure that the module has been
fully inserted into the DIMM slot.
NOTE: For maintaining system stability, do not change any of DDR memory parameters in BIOS setup to upgrade
your system performance without acquiring technical information.
3.2 Installing the Mini ITX
To install your PEB-7605 SERIES into standard chassis or proprietary environment, you need to perform the following
steps:
(1). Check all jumpers setting on proper position
(2). Install and configure CPU and memory module on right position
(3). Place PEB-7605 SERIES into the dedicated position in your system
(4). Attach cables to existing peripheral devices and secure it
NOTE: Please refer section 3.4 to install display and Ethernet drivers and setup your system.
WARNING: Please ensure that your SBC properly inserted and fixed by mechanism. Otherwise, the system might be
unstable or do not work from bad contact of golden finger.
3.2.1 852GM Integrated Graphics Controller
Intel® FW82855GM GMCH integrated Extreme Graphics controller, one DSUB-15 connector for CRT display interface.
Two LVDS connectors for 18bit dual channel LVDS panel display interface. CRT mode :Support Maximum resolution up to
2048 x 1536 for 3D at refresh rates 75Hz. Multiple Maximum overlay display resolution up to 1600 x 1200 (85Hz)
