IEI Technology WSB-G41A-R11, User Manual

Page: 56 / 122

WSB-G41A CPU Card
Page 44
NOTE:
IEI has a wide range of backplanes available. Please contact your
WSB-G41A vendor, reseller or and IEI sales representative at
to find out more about the available chassis.
4.3.5 CPU Card Installation
To install the WSB-G41A CPU card onto the backplane, carefully align the CPU card
interface connectors with the corresponding socket on the backplane. To do this, please
refer to the reference material that came with the backplane. Next, secure the CPU card to
the chassis. To do this, please refer to the reference material that came with the chassis.
4.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The WSB-G41A includes three jumpers shown in Table 4-1 .
Description Label Type
AT/ATX Power Select jumper JAUTO1 2-pin header
Clear CMOS jumper J_CMOS1 3-pin header