IEI Technology TANK-880-Q370 Series, User Manual

Page: 38 / 120

TANK-880-Q370
Page 28
3.7 Powering On/Off the System
WARNING:
Make sure a power supply with the correct input voltage is being fed into
the system. Incorrect voltages applied to the system may cause damage to
the internal electronic components and may also cause injury to the user.

Power on
the system: press the power button for 3 seconds

Power off
the system: press the power button for 6 seconds

The power of this system can be less than 250w-20A.
Figure 3-21: Power Button
3.8 Power
There are two power connectors on the rear panel. Power 1 connector is a 3-pin terminal
block that supports ACC On signal. Power 2 connector is a DIN connector that can directly
connect to a power adapter. The supported power input voltages are:

Power 1 (terminal block) : 9 V~ 36 V

Power 2 (DC jack) : 9 V ~ 36 V