TANK-610-BW Em b e d d e d S ys te m
P a g e 20
S te p 6:
Insert four retention screws, two in each bracket, to secure the system to the
wall.
3.5.2
Mo u n tin g with VES A Mo u n t Kit (Op tio n a l)
To mount the embedded system onto a wall using the optional VESA 100 wall mount kit,
please follow the steps below.
S te p 1:
Select the location on the wall for the wall-mounting bracket.
S te p 2:
Carefully mark the locations of the four bracket screw holes on the wall.
S te p 3:
Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
S te p 4:
Align the wall-mounting bracket screw holes with the pilot holes.
S te p 5:
Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (
Figure 3-11: Wall-mounting Bracket
S te p 6:
Insert the four monitor mounting screws provided in the wall mounting kit into the
four screw holes on the bottom panel of the system and tighten until the screw
shank is secured against the bottom panel (
Summary of Contents for TANK-610-BW
