IEI Technology SSW-iLW, Installation Manual

Page: 9 / 13

www.ieib.com Page 9 of 13 6050723 Rev 1.0
Wiegand formats
If there is need to change your Wiegand format from 26 bit , use the chart below
92 #
Options # Value # * *
1. –Wiegand format 1 – 8 ( Defaults to 1 = 26 Bit )
2. –Inter Pulse spacing 1 – 225 ( Defaults to 32 = 640
usecs)
3. –Pulse width 1 – 255 ( Defaults to 8 = 160
usecs)
93 # ID type # ID Value # * *
0 – Site ID 0 – 999 ( Deafults to 0 )
1 – Group ID 0 – 999 Defaults to 0 )
Wiegand Formats
Format Frame size PIN’s Sites Groups
1 26 Bit 65536 256 N/A
2 28 Bit 32768 256 N/A
3 29 Bit 524288 256 N/A
4 30 Bit 65536 256 16
5 31 Bit 65336 256 32
6 32 Bit 65536 2048 64
7 36 Bit 1048576 256 N/A
Self Test: After installation it is recommended that you
perform the self test mode. While the unit is powered
up, enter the following on the SSiLW keypad:
7890#123456 * . If all 12 key presses have been
verified, the keypad will enter self test mode. The
LED’s will alternate three times and the sounder will
beep three times followed by a flickering yellow LED.
Press any key to return to normal operation.
System Defaults:
The SS-iLW series keypad is designed for easy
installation in a minimum amount of time. The
following values have been factory programmed.
Front end designation
HFE ( Hub front end)
SS-iLW Keypad program code 6789
Audible keypress fedback on
Visual keypress feedback on
Log event recording on
If it is necessary to change any of these defaults,
please refer to your programming options chart after
you have familiarized yourself with the programming
sections.