IEI Technology SSW-iLW, Installation Manual

Page: 8 / 13

www.ieib.com Page 8 of 13 6050723 Rev 1.0
Section: 4 Programming
SSiLW Program Options Chart
If the pre-programmed default values must be changed,
Or additional functions are desired, the following options may be programmed.
To Enter SSiLW Keypad program mode: 099 # “program code”
*
The keypads yellow LED will
flash twice rapidly indicating that you are in program mode. ( The program code for the SSiLW is
6789* )
Change Program Code Press 90 # 0 # 0 # “new code”
*
“repeat code”
*
Below for SS-iLW, 212 SiL & 232 SiL
Visual Key-press feedback on
Press 91 # 0 # 1 #
**
Visual Key-press feedback off Press 91 # 0 # 0 #
**
Audible Key-press feedback on Press 91 # 1 # 1 #
**
Audible key-press feedback off Press 91 # 1 # 0 #
**
Below for SS-iLW Only
Output Selection - Wiegand
Press 91 # 3 # 1 #
**
Output Selection IEI Secured Series Press 91 # 3 # 0 #
**
Secured Series Recording status OUT Press 91 # 4 # 1 #
**
Secured Series Recording Status IN Press 91 # 4 # 0 #
**
Below for SS-iLW Only
Wiegand Red led enable
Press 91 # 5 # 1 #
**
Wiegand Red led disable Press 91 # 5 # 0 #
**
Wiegand Red led state High Press 91 # 6 # 1 #
**
Wiegand Red led state Low Press 91 # 6 # 0 #
**
Wiegand Green led enable Press 91 # 7 # 1 #
**
Wiegand Green led disable Press 91 # 7 # 0 #
**
Wiegand Green led state High Press 91 # 8 # 1 #
**
Wiegand Green led state Low Press 91 # 8 # 0 #
**
Below for SSiLW 212 SiL & 232 SiL
Keypad illumination enable
Press 91 # 11 # 1 # **
Keypad illumination disable Press 91 # 11 # 0 # **
Keypad dimming enable Press 91 # 12 # 1 # **
Keypad dimming disable ( Bright all the time ) Press 91 # 12 # 0 # **
Default SSiLW keypad to IEI controller mode Press 96 # 0 # 0 # **
Default SSiLW keypad to 26 bit wiegand mode Press 96 # 1 # 1 # **
Exit programming
Press * until yellow led stop s flashing
Notes: Programming user codes or relay times cannot be done from the SS-iLW. They must be
changed from the controller.