IEI Technology PUZZLE-IN001A, User Manual

Page: 45 / 107

PUZZLE-IN001A
Page 35
3.14.2 Jumper Settings
To configure the jumper settings, please follow the steps below.
Step 1: Remove the top cover. See Section 3.2 .
Step 2: Locate the jumper/button on the embedded motherboard.
Step 3: Make the jumper settings in accordance with the settings described and defined
in the following sections. Step 0:
3.14.2.1 Clear CMOS
If the PUZZLE-IN001A fails to boot due to improper BIOS settings, the clear CMOS button
clears the CMOS data and resets the system BIOS information. To do this, push the clear
CMOS button for a few seconds.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:

Enter the correct CMOS setting

Load Optimal Defaults

Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS button location is shown in Figure 3-17 below.