PAC-400AI-C236 Embedded System
Page 32
Step 3:
Make sure the power switch is turned on.
Step 4:
Plug the system into a monitor and check to see if anything appears on the
screen. If the boot-up screen appears it means the power LED has failed. To fix
this problem, contact an IEI sales representative directly.
Step 0:
4.2.2 The System Doesn’t Boot Up
If the system doesn’t boot up please do the following:
Step 1:
Check the power is turned on. See
Section 4.2.1
Step 2:
Make sure the SO-DIMM modules are properly installed.
Step 0:
4.2.3 More Troubleshooting
Nothing appears on the monitor after booting up the system
: Make sure the monitor
is properly connected to the system and the monitor is connected to a power supply and
turned on.
WARNING:
If all troubleshooting measures have been taken and the system still
fails to start, contact the IEI reseller or vendor you purchased the
PAC-400AI-C236 from or contact an IEI sales representative directly.
To contact an IEI sales representative, please send an email
to
Summary of Contents for PAC-400AI-C236
