NAS-4100 NETWORK ATTACHED STORAGE SERVICE MANUAL
9.
Press the power button to turn off the system. Turn on the system again and
change the BIOS settings back to the factory default by choosing Load
Optimized Defaults. Take the Firmware Recovery CD out. Select Save &
Exit Setup to reboot. Then turn off the power.
10.
Remove the CD-ROM drive and all the cables. Put the top cover back. Turn
on the power. Make sure the system boots and works properly.
Please remember to continue to configure the system to the factory default
settings, such as initialize disk configuration and create public share. To initialize
system configuration, please refer to chapter 9, “Factory Default Setup.”
IEI CONFIDENTIAL
23
