IEI Technology IDS-310-AL, User Manual

Page: 28 / 114

IDS-310-AL Embedded System
Page 14

Air Circulation : Make sure there is sufficient air circulation when installing
the IDS-310-AL. The IDS-310-AL must not be obstructed by any objects.
Leave at least 5 cm of clearance around the IDS-310-AL to prevent
overheating.

Grounding : The IDS-310-AL should be properly grounded. The voltage feeds
must not be overloaded. Adjust the cabling and provide external overcharge
protection per the electrical values indicated on the label attached to the back
of the IDS-310-AL.
3.2.1 High Surface Temperature
WARNING:
Some surfaces of the equipment may become hot during operation.
The surface temperature may be up to several tens of degrees hotter
than the ambient temperature. Under these circumstances, the
equipment needs to be protected against accidental contact.
The equipment is intended for installation in a RESTRICTED ACCESS LOCATION.

Access can only be gained by SERVICE PERSONS or by USERS who have
been instructed about the reasons for the restrictions applied to the location
and about any precautions that shall be taken.

Access is through the use of a TOOL or lock and key, or other means of
security, and is controlled by the authority responsible for the location.