IEI Technology AFOLUX AFL-315AW/B, User Manual

Page: 60 / 198

AFOLUX Kiosk Application Series
Page 44
The following jumpers are preconfigured for the AFL-315. Users should no change these
jumpers.
Jumper Name Label Type
LVDS voltage selection JP4 3-pin header
Touch Screen Select J4 4-pin header
Panel Type and Resolution JP2 10-pin header
Table 4-2: Preconfigured Jumpers
4.7.3 Clear CMOS Jumper
Jumper Label:
JP1
Jumper Type: 2-pin header
Jumper Settings: See
Table 4-3
Jumper Location: See
Figure 4-5
If the AFL-315 fails to boot due to improper BIOS settings, the clear CMOS jumper clears
the CMOS data and resets the system BIOS information. To do this, use the jumper cap to
close the pins for a few seconds then removel the jumper clip.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 4-3.