IEI Technology AFL4-W10-EHL, User Manual

Page: 33 / 135

AFL4-W10/W12/12/W13-EHL Panel PC
Page 32
▪ Anti-static Discharge : If a user opens the rear panel of the panel PC, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear an anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Unpack the panel PC.
Step 2: Install a M.2 module.
Step 3: Configure the system.
Step 4: Connect peripheral devices to the panel PC.
Step 5: Mount the panel PC.
3.4 Removing the Back Cover
WARNING:
Before any internal installation procedures are carried out on the
system, make sure the system is turned off and cooled down for 15
minutes. Failing to turn off the system before opening it can cause
permanent damage to the system and serious or fatal injury to the user.
To access the AFL4-W10/W12/12/W13-EHL internally the back cover must be removed.
To remove the back cover, please follow the steps below.
Step 1: Remove the retention screws from the back cover ( Figure 3-1 ).