IDTECK Star Finger007, Manual

Page: 95 / 103

p.88 When configuring the device using MASTER ID, suddenly the device goes back to the
normal mode.
* If you initialize the device, baud rate is set to 9,600 bps which is the default.
1.3 Please check if the communication port setting is good.
Check if communication port set in software is same with communication port set in PC.
If the problem persists, please contact service center.
2 Cards which were being used are not authenticated af
ter executing batch transmission of IDs from software
to the device.
2.1 The ID of the card may not be registered to software.
1. Check if the ID is registered to software.
2. If the ID is not registered, register the ID to the software and execute batch transmissio
n of the IDs from software to the device.
If the problem persists, please contact service center.
3 When configuring the device using MASTER ID, sudde
nly the device goes back to the normal mode.
3.1 If you do not input anything for 60 seconds in setting mode, the device goes
back to the normal mode.
To prevent the setting from being changed by one who is not a manager, when the manage
leaves the device in setting mode, the device goes back to the normal mode when there is n
o input for 60 seconds.