IDTECK Star Finger007, Manual

Page: 84 / 103

Setting Changes p.77
DIP Switch
1=ON, 2=OFF (It shows how the DIP switch on the back of the FINGER007 is set.)
Input 1-4
0=OFF (Disabled)
1=ON (Enabled)
2=Input Disconnected
Input 5
The status of the tamper switch inside the FINGER007 (0=OFF (Disabled), 1=ON (Ena
bled))
Input 6
The status of the Proximity Sensor
(0=OFF (Disabled), 1=ON (Enabled))
If you activate the Cut-Off Check feature for all the input ports in “5.IN/OUT DEFIN
E” from F2 Setup menu, the result of an input port test will change to 222200 (If t
ermination resistors are not connected) or 000000 (If termination resistors are con
nected).
4.8 Communication Test
COMM Test allows you to test communication. Prior to the test, connect the RS232-RX wire
(Black wire with White stripe) and the RS232-TX wire (Red wire with Black stripe) together.
To begin the test, press <ENT>.