IDS NXT malibu, Technical Manual

Page: 22 / 56

2023-10-25 22
IDS NXT malibu: Technical Manual
Fig. 9: IDS NXT m alibu - Backside
7. Connect the power supply to the camera. When doing so, pay attention to the respective requirements:
When supplying power via GigE connection: the requirements for the GigE cable and the pin assignment of
the GigE connector (RJ45, 8-pin)
When supplying power via I/O connector: the requirements for the I/O cable and the pin assignment and
notes on the I/O connection
8. Check if your camera is supplied with power (LEDs are flashing).
9. Connect the camera to a Gigabit Ethernet port on the PC either directly or using switches. Please note the
requirements .
ð
In the next step, set up the camera within the network. To do this, follow the steps in section Setting up the
camera in the network .
ð
For information on using the inputs and outputs, refer to the sections Setting up the I/O interfaces of the
camera and Electrical data .
5.1 Prerequisites for installation
Host PC: IDS NXT cockpit is currently available for Windows 64-bit. You should have an up-to-date graphics
card driver installed for an optimal display.
I/O cable: When using the I/O interface the following applies: The maximum length of the I/O cable is 30 m.
The cable must be shielded.
GigE cable : Use Cat5e type cables or better for the complete connection between your camera and the host
PC. The cable length of each segment must not exceed 100 m. A segment is in this case a continuous cable
connection between two network devices (e.g. PC, camera, switch).
The requirements for setting up the camera in the network can be found in section Requirements for the setting
up in the network .
Always store camera and lens with the protective cap mounted.