IDS LCD Digital Keypad, User Manual, Page: 25 / 32

25
IDS LCD Keypad User Manual 700-292-01C Issued March 2009
1. Select the required stay profile (See 9.1)
2. Hold down the [3] key until the keypad buzzer sounds. The LCD keypad will indicate that the
panel is in Stay mode alongside the partition number.
3. Press the [NUMBER] corresponding to the zone you wish to be a STAY zone followed by the [ * ]
key. Alternatively use the [PANIC] or [MED] keys to scroll through the zones.
4. A [Y] next to a zone number indicates that that particular zone is programmed as a stay zone.
NOTE:
Buzz zones will be shown by flashing indicators. (See Section 8). A Buzz zone cannot be selected as a
Stay Zone. The Buzz status must be cleared first.
5. Repeat step 3 until the selection of stay zones is completed.
6. Press the [#] key to exit the stay zone programming mode.
9.3 How to Cancel Stay Zones
HOLD [3] + [ZONE NUMBER] + [*] + [#]
1.
Select the required Stay Profile (See 9.1)
2.
Hold down the [3] key until the keypad buzzer sounds. The LCD display will indicate that the
panel is in the Stay Zone programming mode.
3.
Press the [NUMBER] corresponding to the STAY zone you wish to cancel followed by the [ * ]
key. Alternatively use the [PANIC] and [MED] keys to scroll through zones.
4.
A [N] next to the zone number indicates that the zone is not selected as a stay zone.
5.
Repeat step 3 until all the required stay zones have been cancelled.
6.
Press the [#] key to exit the stay zone programming mode.
10. Buzz Zones
Violation of a buzz zone when Stay Armed will cause the keypad buzzer to sound for a period of 30
seconds during which time a valid user code must be entered. If a valid user code is not entered during
this period, the system will register an alarm condition. This feature helps prevent unnecessary false
alarms.
NOTE:
If an Entry/Exit zone is programmed as a buzz zone, violation of the Entry/Exit zone (when the panel is
Stay Armed) will cause the keypad buzzer to sound for the duration of the entry delay time. This, if the
panel is stay armed, allows the user to enter the premises and disarm the panel.
If it is not programmed as a buzz zone, the alarm will be triggered immediately. If the panel was armed
using the [6] key (Stay Arm and Go) violation of the Entry/Exit zone will always start the Entry/Exit delay.
10.1 How to Program Buzz Zones
HOLD [4] + [ZONE NUMBER] + [*] + [#]
1. Select the required Stay Profile. (See 9.1)
2. Hold down the [4] key until the keypad buzzer sounds. The LCD Display will indicate that the
keypad is in Buzz Mode.