IDS LCD Digital Keypad, User Manual, Page: 11 / 32

11
IDS LCD Keypad User Manual 700-292-01C Issued March 2009
2. As soon as the Entry/Exit zone is violated, the entry delay will begin. The keypad buzzer will
sound for the duration of the entry period. The above 2 points only apply if the premises are away
armed.
3. Press the [#] key and enter a valid [USER CODE]. If an error beep occurs, press the [#] key and
re-enter the user code.
4. Once the system disarms, the ARM indicator will turn off and the keypad buzzer will stop
sounding.
5. If no valid user code has been entered prior to the expiry of the entry delay period an alarm
condition will be registered.
6. If the entry period is too short, have your installer change the entry delay period.
NOTE:
If a strobe (or flashing light) has been installed and an alarm condition is registered, the strobe will
continue flashing after the siren has stopped sounding. Entering a valid [USER CODE] will cancel the
strobe.
3.2 How to Disarm using a Key-Switch or Remote
1. Activate the remote or key-switch.
2. The system will disarm and the remote indicator (if installed) will turn off. If the siren toot on
disarm option is enabled, the siren will provide a double toot when the panel is disarmed.
4. Bypassing Zones

The term BYPASS is used to describe a zone which has been deactivated; i.e. violation of a
bypassed zone is ignored and will not cause an alarm condition.

Once the system is armed, it is not possible to bypass zones.

All bypassed zones will be automatically cancelled each time the panel is disarmed and must be
re-bypassed before the next arming.
4.1 How to Bypass a Zone
Hold down [9] + [ZONE NUMBER] + [*] + [#]
1. Ensure the panel is not armed.
2. To enter bypass mode, hold down the [9] key for two seconds until the keypad buzzer sounds
and all LED's are off.
3. The LCD display reads 'Bypassed'. Using the [PANIC] and [MED] keys, one is able to scroll
through the zones. Alternatively press the number of the zone you wish to bypass e.g. the [2] key
if you wish to bypass zone 2, then press the [ * ] key.
4. [Y] indicates that the zone has been bypassed, whilst [N] indicates that the zone has not been
bypassed.
5. Repeat step 3 to bypass other zones.
6. Press the [#] key to exit the bypass mode.
NOTE:
Panic zones cannot be bypassed.